Friday, May 7, 2021

2010 Cadillac CTS Sedan AWD V6-3.6L Page 631

2010 Cadillac CTS Sedan AWD V6-3.6L Page 631



* Ground circuit terminal 4



瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.



3. Disconnect the X1 harness connector at the K48 keyless entry control module.



4. Ignition ON, test for greater than 10 V between the signal circuit terminal listed below and ground.



* Signal circuit terminal 2



* Signal circuit terminal 3



瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace



the S84D door lock/window switch-driver.



5. Ignition OFF, connect the X1 harness connector at the K48 keyless entry control module and disconnect the X6 harness connector at the



S84D door lock/window switch-driver.



6. Ignition ON, test for greater than 10 V between the signal circuit terminal 2 and ground.



瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace



the K48 keyless entry control module.



7. If all circuits test normal, test or replace the B27D door handle switch-driver.



Component Testing



1. Ignition OFF, disconnect the harness connector at the B27D door handle switch-driver.



2. Test for infinite resistance between the signal terminal 2 and the ground terminal 1 with the switch in the open position.



瀚慖f not the specified value, replace the B27D door handle switch-driver.



3. Test for less than 2 ohm between the signal terminal 2 and the ground terminal 1 with the switch in the closed position.



4. If greater than the specified range, replace the B27D door handle switch-driver.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Front Side Door Outside Handle Replacement (Front and Rear Doors with ATH) (See: Body and Frame/Doors, Hood and



Trunk/Doors/Front Door/Front Door Handle/Front Door Exterior Handle/Service and Repair)Front Side Door Outside Handle Replacement



(Front Door with ATH) (See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Handle/Front Door Exterior



Handle/Service and Repair)Front Side Door Outside Handle Replacement (Without ATH) (See: Body and Frame/Doors, Hood and



Trunk/Doors/Front Door/Front Door Handle/Front Door Exterior Handle/Service and Repair)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for driver door lock/window switch and keyless



entry control module replacement, setup, and programming



B3873



DTC B3873



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)provides an overview of each diagnostic category.



DTC Descriptor



DTC B3873 00



- Front Washer Relay Circuit



Diagnostic Fault Information

No comments:

Post a Comment