Tuesday, May 18, 2021

2010 Cadillac CTS Sedan AWD V6-3.6L Page 1109

2010 Cadillac CTS Sedan AWD V6-3.6L Page 1109



circuit/connections test normal, replace the ECM.



5. Verify that the following conditions do not exist:



* Lean, rich, or leaking fuel injectors.



* A fuel pressure that is too low or too high-Refer to Fuel System Diagnosis (See: Powertrain Management/Computers and Control



Systems/Testing and Inspection/Component Tests and General Diagnostics/Fuel System Diagnosis).



* Fuel that is contaminated-Refer to Alcohol/Contaminants-in-Fuel Diagnosis (with Special Tool) (See: Powertrain



Management/Computers and Control Systems/Testing and Inspection/Component Tests and General



Diagnostics/Alcohol/Contaminants-in-Fuel Diagnosis (with Special Tool))Alcohol/Contaminants-in-Fuel Diagnosis (without Special



Tool) (See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Component Tests and General



Diagnostics/Alcohol/Contaminants-in-Fuel Diagnosis (without Special Tool)).



* Evidence of water intrusion into the electrical connector of the HO2S



* The HO2S is loose



* Exhaust leaks near the HO2S



* Engine vacuum leaks



瀚慖f you find any of the above conditions, repair as necessary.



6. If all circuits/connections test normal, replace the appropriate HO2S sensor.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Heated Oxygen Sensor Replacement - Bank 1 Sensor 1 (LF1) (See: Powertrain Management/Computers and Control Systems/Oxygen



Sensor/Service and Repair)Heated Oxygen Sensor Replacement - Bank 1 Sensor 1 (LLT) (See: Powertrain Management/Computers and



Control Systems/Oxygen Sensor/Service and Repair)



* Heated Oxygen Sensor Replacement - Bank 2 Sensor 2 (LF1) (See: Powertrain Management/Computers and Control Systems/Oxygen



Sensor/Service and Repair)Heated Oxygen Sensor Replacement - Bank 2 Sensor 2 (LLT) (See: Powertrain Management/Computers and



Control Systems/Oxygen Sensor/Service and Repair)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for engine control module replacement, setup, and



programming



P0160



DTC P0137, P0138, P0140, P0157, P0158, or P0160 (With LLT)



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0137



- HO2S Circuit Low Voltage Bank 1 Sensor 2



DTC P0138



- HO2S Circuit High Voltage Bank 1 Sensor 2



DTC P0140



- HO2S Circuit Insufficient Activity Bank 1 Sensor 2



DTC P0157



- HO2S Circuit Low Voltage Bank 2 Sensor 2



DTC P0158



- HO2S Circuit High Voltage Bank 2 Sensor 2



DTC P0160



- HO2S Circuit Insufficient Activity Bank 2 Sensor 2



Diagnostic Fault Information

No comments:

Post a Comment