2010 Cadillac CTS Sedan AWD V6-3.6L Page 694
DTC C0245
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC C0245 5A
- Wheel Speed Sensor Plausibility Failure
Circuit/System Description
As the wheel spins, the wheel speed sensor (WSS) produces an alternating current (AC) signal. The electronic brake control module (EBCM) uses
the frequency of the AC signal to calculate the wheel speed.
Conditions for Running the DTC
* Ignition ON.
* Ignition voltage is greater than 10 volts.
* Vehicle must be moving at a speed less than 14.5 km/h (9 mph).
* No wheel speed sensor faults exist.
* Brake is not applied.
* Vehicle is not cornering.
* No wheel spinning is detected.
Conditions for Setting the DTC
Wheel speed differences between one wheel and the others is greater than 25 percent.
Action Taken When the DTC Sets
* The EBCM inhibits Antilock brake system (ABS), traction control system (TCS) and vehicle stability enhancement system (VSES).
* A DIC message and/or a warning indicator may be displayed.
Conditions for Clearing the DTC
* The condition for the DTC is no longer present.
* The EBCM clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles.
Diagnostic Aids
* Faulty wheel speed sensor will not set this DTC.
* A vehicle using a space saver spare will not set this code.
Reference Information
Schematic Reference
Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit
Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)
No comments:
Post a Comment