Wednesday, April 28, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 239

2010 Cadillac Truck SRX FWD V6-3.0L Page 239



Schematic Reference



Instrument Cluster Schematics (See: Diagrams/Electrical Diagrams/Instrument Panel, Gauges and Warning Indicators/System Diagram/Instrument



Cluster Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Instrument Cluster Description and Operation (See: Instrument Panel, Gauges and Warning Indicators/Description and Operation/Instrument



Cluster)



Driver Information Center (DIC) Description and Operation (See: Instrument Panel, Gauges and Warning Indicators/Description and



Operation/Driver Information Center (DIC))



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



Ignition ON, observe the scan tool Ambient Air Temperature parameter. The reading should be between -40掳C (-40掳F) to +88掳C (+190掳F) and



change with air temperature changes.



Circuit/System Testing



1. Ignition OFF, disconnect the harness connector at the B9 Ambient Air Temperature Sensor.



2. Ignition ON, test for 4.8-5.2 V between the signal circuit terminal A and ground.



瀚慖f greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the P16 Instrument



Cluster.



瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace



the P16 Instrument Cluster.



3. Install a 3 A fused jumper wire between the signal circuit terminal A and the low reference circuit terminal B. Verify the scan tool Ambient



Air Temperature parameter displays greater than 54 掳C (130 掳F).



瀚慖f less than the specified range, test the low reference circuit a short to voltage or an open/high resistance. If the circuit tests normal,



replace the P16 Instrument Cluster.



4. If all circuits test normal, test or replace the B9 Ambient Air Temperature Sensor.



Component Testing



Static Test



1. Test the B9 Ambient Air Temperature Sensor by varying the sensor temperature while monitoring the sensor resistance.



2. Compare the readings with the Ambient Air Temperature Sensor Resistance (See: Heating and Air Conditioning/Ambient Temperature



Sensor / Switch HVAC/Specifications).



瀚慖f not within the specified range, replace the B9 Ambient Air Temperature Sensor.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Ambient Air Temperature Gauge Sensor Replacement (See: Instrument Panel, Gauges and Warning Indicators/Outside Temperature



Display/Outside Temperature Display Sensor/Service and Repair)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for module replacement, programming and setup

No comments:

Post a Comment