Sunday, April 25, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 1562

2010 Cadillac Truck SRX AWD V6-3.0L Page 1562



* The TCM freezes transmission adaptive functions.



* The TCM commands the torque converter clutch (TCC) OFF.



* The TCM allows the transmission to operate in reverse and fifth range.



* The TCM inhibits Tap Up/Down function.



* The TCM inhibits manual shifting of forward gears.



Conditions for Clearing the DTC



* DTCs P0562 and P0563 are Type C DTCs.



* DTC P2534 is a Type A DTC.



Diagnostic Aids



* Observe the driver information center (DIC) messaging that would indicate the electrical system requires service.



* Running the engine with a battery charger attached may cause DTC P0563 to set.



* Inspect for the following conditions:



- Loose or damaged terminals at the generator



- Loose or worn generator drive belt



Reference Information



Schematic Reference



Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams)



Connector End View Reference



* Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



* Inline Harness Connector End Views (See: Diagrams/Connector Views/Multiple Junction Connector/Connector End Views By Number)



Description and Operation



Transmission General Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and Operation/6T70/6T75 -



Automatic Transmission/Transmission General Description)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Special Tools



DT-47825-20 Adapter Harness



Circuit/System Verification



1. Engine running, accessories OFF, measure and record the battery voltage at the battery terminals. The voltage should be between 12.6-15.0



volts.



瀚慖f the voltage is not within the specified range, or the charge indicator light is ON, refer to Charging System Test (See: Starting and



Charging/Testing and Inspection/Component Tests and General Diagnostics/Charging System Test).



2. Observe the scan tool TCM Ignition Voltage parameter. The reading should be between 12.6-15.0 volts.



3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the



conditions that you observed from the Freeze Frame/Failure Records data.



Circuit/System Testing



1. Ignition OFF, disconnect the 20-way harness connector at the transmission.

No comments:

Post a Comment