Friday, April 23, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 1615

2010 Cadillac Truck SRX AWD V6-3.0L Page 1615



- Generator L-Terminal Circuit



Diagnostic Fault Information



Circuit/System Description



The engine control module (ECM) uses the generator turn ON control circuit to control the load of the generator on the engine. A high side driver



in the ECM applies a voltage to the voltage regulator. This controls the voltage regulator to turn the field circuit ON and OFF. The ECM monitors



the state of the generator turn ON control circuit. The ECM should detect low voltage on generator turn on control circuit when the ignition is ON



and the engine is OFF, or when the charging system malfunctions. With the engine running, the ECM should detect high voltage on the generator



turn on control circuit.



Conditions for Running the DTC



* The ignition ON, engine OFF for ignition on test.



* The engine is running for the run test.



Conditions for Setting the DTC



* During the ignition on test, the ECM detects voltage on the generator turn on control circuit for 5 seconds.



* During the run test, the ECM detects low voltage on the generator turn on control circuit for 15 seconds.



Action Taken When the DTC Sets



DTC P0621 is a C type DTC.



Conditions for Clearing the DTC



DTC P0621 is a C type DTC.



Reference Information



Schematic Reference



Starting and Charging Schematics (See: Starting and Charging/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Charging System Description and Operation (See: Starting and Charging/Charging System/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Testing

No comments:

Post a Comment