2010 Cadillac CTS Sedan AWD V6-3.6L Page 797

2010 Cadillac CTS Sedan AWD V6-3.6L Page 797

瀚慖f not within the specified range, replace the G18 high pressure fuel pump.

3. Measure the resistance between each terminal and the high pressure fuel pump housing. The DMM should display OL.

瀚慖f less than the specified value, replace the G18 high pressure fuel pump.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Fuel Pump Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Pump/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming

P000D

DTC P000A-P000D, P0011, P0014, P0021, or P0024 (Without LF1)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P000A

- Intake Camshaft Position System Slow Response Bank 1

DTC P000B

- Exhaust Camshaft Position System Slow Response Bank 1

DTC P000C

- Intake Camshaft Position System Slow Response Bank 2

DTC P000D

- Exhaust Camshaft Position System Slow Response Bank 2

DTC P0011

- Intake Camshaft Position System Performance Bank 1

DTC P0014

- Exhaust Camshaft Position System Performance Bank 1

DTC P0021

- Intake Camshaft Position System Performance Bank 2

DTC P0024

- Exhaust Camshaft Position System Performance Bank 2

Circuit/System Description

The camshaft position actuator system enables the Engine Control Module (ECM) to change the timing of the camshafts while the engine is

operating. The camshaft position actuator solenoid signal from the ECM is pulse width modulated (PWM). The ECM controls the camshaft position

actuator solenoid duty cycle by controlling the amount of solenoid ON time. The camshaft position actuator solenoid controls the advance or the

retard of each camshaft. The camshaft position actuator solenoid controls the oil flow that applies the pressure to advance or retard the camshafts.

Conditions for Running the DTC

* Before the ECM can report DTC P000A, P000B, P000C, P000D, P0011, P0014, P0021, or P0024 failed, DTCs P0010, P0013, P0020,

P0023, P0341, P0342, P0343, P0346, P0347, P0348, P0366, P0367, P0368, P0391, P0392, P0393, P2088, P2089, P2090, P2091, P2092,

P2093, P2094, and P2095 must run and pass.

* DTC P0016, P0017, P0018, P0019, P0335, P0336, or P0338 is not set.

* The engine is operating for greater than 1 seconds.

* The engine speed is greater than 520 RPM.

* The engine must accelerate such that the CMP actuator system is commanded from the park position to the phased position. This is

considered a cam control cycle. There must be a minimum of 2 cam control cycles for at least 2.5 seconds each in the phased position.