2010 Cadillac CTS Sedan AWD V6-3.6L Page 975

2010 Cadillac CTS Sedan AWD V6-3.6L Page 975

Perform the clutch pedal position sensor learn procedure.

Circuit/System Testing

Perform the clutch pedal position sensor learn procedure.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Clutch Pedal Position Sensor Learn (See: Transmission and Drivetrain/Manual Transmission/Transaxle/Testing and

Inspection/Programming and Relearning/Aisin AY6 - Manual Transmission)

* Control Module References (See: Testing and Inspection/Programming and Relearning)for ECM replacement, setup and programming

Tremec 6-Speed - Manual Transmission

DTC P080A

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions)provides an overview of each diagnostic category.

DTC Descriptor

DTC P080A

- Clutch Pedal Position (CPP) Not Learned

Circuit/System Description

The clutch pedal position (CPP) is a three wire sensor, connected to a 5-volt reference circuit, a low reference circuit, and a signal circuit. The

engine control module (ECM) supplies 5-volts to the CPP sensor, and also provides a sensor ground path on the low reference circuit. The CPP

sensor sends a voltage signal to the ECM on the signal circuit. The voltage on the signal circuit will vary from a voltage less than or equal to 5-volts

when the clutch pedal is released to a voltage less than or equal to 1.5-volts when the clutch pedal is applied.

Conditions for Running the DTC

Clutch pedal fully applied.

Conditions for Setting the DTC

Clutch pedal position not learned.

Action Taken When the DTC Sets

P080A is a Type B DTC.

Conditions for Clearing the MIL/DTC

P080A is a Type B DTC.

Reference Information

Schematic Reference

Manual Transmission Schematics (See: Transmission and Drivetrain/Manual Transmission/Transaxle/Diagrams/Electrical Diagrams/Tremec

6-Speed - Manual Transmission)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Manual Transmission Description and Operation (See: Transmission and Drivetrain/Manual Transmission/Transaxle/Description and

Operation/Tremec 6-Speed - Manual Transmission/Manual Transmission Description and Operation)

Electrical Information Reference