2010 Cadillac CTS Sedan AWD V6-3.6L Page 396

2010 Cadillac CTS Sedan AWD V6-3.6L Page 396

瀚慖f not the specified value, replace the passenger exterior door handle.

3. With the switch in the closed position, test for less than 1 ohm between the signal terminal and the ground terminal listed below:

* Terminal E and Terminal F

* Terminal B and Terminal C

瀚慖f greater than the specified range, replace the passenger exterior door handle.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Front Side Door Outside Handle Replacement (Front and Rear Doors with ATH) (See: Body and Frame/Doors, Hood and

Trunk/Doors/Front Door/Front Door Handle/Front Door Exterior Handle/Service and Repair)Front Side Door Outside Handle Replacement

(Front Door with ATH) (See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Handle/Front Door Exterior

Handle/Service and Repair)Front Side Door Outside Handle Replacement (Without ATH) (See: Body and Frame/Doors, Hood and

Trunk/Doors/Front Door/Front Door Handle/Front Door Exterior Handle/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for PDM and RCDLR replacement, setup, and

programming

B1475

DTC B1475

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions)provides an overview of each diagnostic category.

DTC Descriptor

DTC B1475 00

- Retained Accessory Power Circuit

Diagnostic Fault Information

Circuit/System Description

The body control module (BCM) controls the RAP relay through the rap relay coil supply voltage circuit by applying voltage to the coil side of the

relay. The RAP relay is energized when any of the following conditions are true:

* Ignition switch is in ACC or ON.

* The vehicle was remote started.

* The vehicle is in RAP mode.

Conditions for Running the DTC

* The system voltage is between 9-16 volts.

* The DTC can only set when the output is actively being requested by the module.

Conditions for Setting the DTC

The DTC will set only when the module requests the output and there is a short to ground in the rap relay coil supply voltage circuit.

Action Taken When the DTC Sets

The module output driver will be shut down and not supply voltage to the circuit.