2010 Cadillac CTS Sedan AWD V6-3.6L Page 507
DTC B2580 00
- Headlamp High Beam Control Circuit
Diagnostic Fault Information
Circuit/System Description
When the turn signal/multifunction switch is placed in the headlamps high or flash to pass (FTP) position, ground is applied to the body control
module (BCM) through the headlamp high beam signal circuit or the flash to pass switch signal circuit. The BCM applies ground to the headlamp
high beam relay control circuit which energizes the high beam relay. With the high beam relay energized, the switch contacts close allowing battery
voltage to flow through the HI BEAM fuses to the high beam headlamps.
Conditions for Running the DTC
* Battery voltage must be between 9-16 V.
* Headlamps ON.
Conditions for Setting the DTC
The BCM detects a short to voltage in the headlamp high beam relay control circuit.
Actions Taken When the DTC Sets
The high beam headlamps and flash to pass (FTP) will not operate.
Conditions for Clearing the DTC
* The condition responsible for setting the DTC no longer exists.
* A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.
Reference Information
Schematic Reference
Headlights/Daytime Running Lights (DRL) Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System
Diagram/Headlights/Daytime Running Lights (DRL) Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems Description
and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit
Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)
No comments:
Post a Comment