2010 Cadillac CTS Sedan AWD V6-3.6L Page 522

2010 Cadillac CTS Sedan AWD V6-3.6L Page 522

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

1. Ignition ON, Clear the DTC. Observe the scan tool BCM Brake Applied Output Signal parameter. The parameter should change from ON to

OFF when the brake pedal is depressed and released.

瀚慖f the parameter does not change, refer to Stop Lamps Malfunction (See: Lighting and Horns/Testing and Inspection/Symptom Related

Diagnostic Procedures/Stop Lamps Malfunction).

2. Press the brake pedal, the vehicle operator should not be able to move the shifter lever out of the PARK position.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the shift lock control solenoid.

2. Ignition OFF, test for less than 1.0 ohm between the ground circuit terminal B and ground.

瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.

3. Install a test lamp between the ground circuit terminal B and the control circuit terminal A.

4. Ignition ON, command the BCM scan tool Shift Lock Solenoid output control ON and OFF. The test lamp should turn ON and OFF as

commanded.

瀚慖f the test lamp is always ON, test the control circuit for short to voltage. If the circuit tests normal, replace the BCM.

瀚慖f the test lamp is always OFF, test the control circuit for short to ground or an open/high resistance. If the circuit tests normal, replace the

BCM.

5. If the circuit tests normal, test or replace the shift lock control solenoid.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Transmission Control Replacement (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter A/T/Service and

Repair/Transmission Control Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming

B2750

DTC B2750

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC B2750 00

- Horn Relay Coil Circuit

Diagnostic Fault Information