2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2773

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2773

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Circuit/System Verification

With a scan tool, ensure the following DTCs are not present in the modules as follows:

BCM

* U1814

* U2099

SDGM

* U1812

* B1453

If any listed DTC is present, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code Descriptions/Diagnostic

Trouble Code (DTC) List - Vehicle) to diagnose that DTC prior to this diagnostic.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector X2 at the SDGM.

2. Verify less than 0.5 volts between the wake up signal circuit terminal 19 and ground.

瀚慖f greater than the specified range, test the circuit for a short to voltage. If the circuit tests normal, replace the BCM.

3. Ignition ON, verify B+ between the communication enable signal circuit terminal 16 and ground.

瀚慖f less than the specified value, test the circuit for an open/high resistance. If the circuit tests normal, replace the BCM.

4. If all circuits test normal, replace the SDGM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

GMLAN Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Wiring Repairs/GMLAN Wiring Repairs)

U209D

DTC U209D

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC U209D 00

- Battery Energy Control Module High Speed Communication Enable Circuit High

Diagnostic Fault Information

Circuit/System Description

Modules connected to the LAN serial data circuits monitor for serial data communications during normal vehicle operation. Operating information