2010 Cadillac Truck SRX AWD V6-3.0L Page 167
Action Taken When the DTC Sets
The SIR System is disabled and no deployments are allowed.
Conditions for Clearing the DTC
* The DTC will be current for as long as the fault is present
* When the fault is no longer present, the DTC will be a history DTC
* A history DTC will clear after 50 ignition cycles
Reference Information
Schematic Reference
SIR Schematics (See: Diagrams/Electrical Diagrams/Air Bag Systems)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
SIR System Description and Operation (See: Restraints and Safety Systems/Air Bag Systems/Description and Operation/SIR System)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
1. Ignition ON, with the passenger seat unoccupied, verify the scan tool Passenger Seat Occupancy Status parameter is Empty Seat.
2. With the passenger seat occupied, verify the scan tool Passenger Seat Occupancy Status parameter is Occupied.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the B60 seat belt reminder sensor.
2. Test for less than 30 ohm between the ground circuit terminal 2 and ground.
瀚慖f greater than the specified range, test the ground circuit for an open/high resistance. If the circuit tests normal, replace the K36 SDM
3. Ignition ON, test for 4.75-5.25 V between the signal circuit terminal 1 and ground.
瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace
the K36 SDM.
瀚慖f greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the K36 SDM.
4. If all circuits test normal, replace the B60 seat belt reminder sensor.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Inflatable Restraint Front Passenger Presence Sensor Replacement (See: Restraints and Safety Systems/Air Bag Systems/Seat Occupant
Sensor/Service and Repair/Inflatable Restraint Front Passenger Presence Sensor Replacement)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for SDM replacement, setup, and programming
B0083
DTC B0083-B0088
Diagnostic Instructions
No comments:
Post a Comment