2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2079

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2079

terminal 2 and ground.

瀚慖f greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.

3. Ignition ON, test for 4.8-5.2 volts between the 5-volt reference circuit terminal 3 and ground.

瀚慖f less than the specified range, test the 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal,

replace the ECM.

瀚慖f greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the ECM.

4. Verify the scan tool FTP sensor parameter is less than 0.2 volts.

瀚慖f greater than the specified range, test the signal circuit terminal 1 for a short to voltage. If the circuit tests normal, replace the ECM.

5. Install a 3 A fused jumper wire between the signal circuit terminal 1 and the 5-volt reference circuit terminal 3. Verify the scan tool FTP

sensor parameter is greater than 4.7 volts.

瀚慖f less than the specified range, test the signal circuit for short to ground or an open/high resistance. If the circuit tests normal, replace the

ECM.

6. If all circuits test normal, test or replace the FTP sensor.

Repair Instructions

* For DTC P0452 or P0453, always perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic

procedure

* For DTC P0451 or P0454, clear DTCs with a scan tool

* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup and programming

P0454

DTC P0451-P0454

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0451

- Fuel Tank Pressure (FTP) Sensor Performance

DTC P0452

- Fuel Tank Pressure (FTP) Sensor Circuit Low Voltage

DTC P0453

- Fuel Tank Pressure (FTP) Sensor Circuit High Voltage

DTC P0454

- Fuel Tank Pressure (FTP) Sensor Intermittent

Diagnostic Fault Information

Typical Scan Tool Data