Monday, November 2, 2020

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1812

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1812

Circuit/System Description

To improve vehicle shift feel, the transmission control module (TCM) is constantly sending the engine control module (ECM) serial data messages

with information regarding its request for modifying engine speed or torque. The ECM sets this code when it detects a discrepancy in the structure

of this message causing its integrity to be questioned.

An intermittent fault in the controller area network (CAN) circuits will cause DTC P150C to set.

Conditions for Running the DTC

* The engine run time is greater than 5 seconds.

* No other CAN errors are present.

Conditions for Setting the DTC

* DTC P150C is a Type B DTC.

* An intermittent fault in the CAN circuits.

Action Taken When the DTC Sets

* DTC P150C is a Type B DTC.

* The TCM commands maximum line pressure during shifts, which results in very harsh shifts.

Conditions for Clearing the DTC

DTC P150C is a Type B DTC.

Reference Information

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Circuit/System Verification

1. DTC P150C is an informational DTC. Diagnose all other Engine Control DTCs prior to DTC P150C. Refer to Diagnostic Trouble Code

(DTC) List - Vehicle (See: Diagnostic Trouble Code Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle).

2. If there are no other Engine Controls DTCs, diagnosis is accomplished by looking for an intermittent CAN circuit fault. Refer to Scan Tool

Does Not Communicate with High Speed GMLAN Device (See: Powertrain Management/Computers and Control Systems/Information

Bus/Testing and Inspection/Symptom Related Diagnostic Procedures/Scan Tool Does Not Communicate with High Speed GMLAN Device).

P0151

DTC P0131, P0132, P0137, P0138, P0151, P0152, P0157, or P0158

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0131

- HO2S Circuit Low Voltage Bank 1 Sensor 1

DTC P0132

- HO2S Circuit High Voltage Bank 1 Sensor 1

DTC P0137

- HO2S Circuit Low Voltage Bank 1 Sensor 2

DTC P0138

- HO2S Circuit High Voltage Bank 1 Sensor 2

No comments:

Post a Comment