2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2487

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2487

瀚慖f greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit/connections test normal, replace

the ECM.

3. Ignition ON, test for 4.8-5.2 V between the appropriate 5 V reference circuit terminal listed below and ground.

* APP sensor 1 terminal D or 2

* APP sensor 2 terminal C or 1

瀚慖f less than the specified range, test the 5 V reference circuit for a short to ground or open/high resistance. If the circuit/connections test

normal, replace the ECM.

瀚慖f greater than the specified range, test the 5 V reference circuit for a short to voltage. If the circuit/connections test normal, replace the

ECM.

4. Observe the scan tool APP sensor 1 voltage parameter. Verify the voltage is less than 0.3 V.

瀚慖f greater than the specified range, test the signal circuit terminal E or 3 for a short to voltage. If the circuit/connections test normal,

replace the ECM.

5. Observe the scan tool APP sensor 2 voltage parameter. Verify the voltage is less than 0.3 V.

瀚慖f greater than the specified range, test the signal circuit terminal B or 6 for a short to voltage. If the circuit/connections test normal,

replace the ECM.

6. Connect a 3 A fused jumper wire between the APP sensor 1 signal circuit terminal E or 3 and the 5 V reference circuit terminal C or 1. Verify

the APP sensor 1 voltage parameter is greater than 4.8 V.

瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit/connections test

normal, replace the ECM.

7. Connect a 3 A fused jumper wire between the APP sensor 2 signal circuit terminal B or 6 and the 5 V reference circuit terminal C or 1.

Verify the APP sensor 2 voltage parameter is greater than 4.8 V.

瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit/connections test

normal, replace the ECM.

8. If all circuits/connections test normal, test or replace the Accelerator Pedal Assembly.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the repair.

* Accelerator Pedal Position Sensor Replacement (See: Powertrain Management/Computers and Control Systems/Accelerator Pedal Position

Sensor/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for Engine Control Module replacement,

programming, and setup

P2125

DTC P2120, P2122, P2123, P2125, P2127, P2128, or P2138

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provide an overview of each diagnostic category.

DTC Descriptors

DTC P2120

- Accelerator Pedal Position (APP) Sensor 1 Circuit

DTC P2122

- Accelerator Pedal Position (APP) Sensor 1 Circuit Low Voltage

DTC P2123

- Accelerator Pedal Position (APP) Sensor 1 Circuit High Voltage