2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2198

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2198

DTC P0634

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC P0634

- Transmission Control Module (TCM) Overtemperature

Circuit/System Description

The transmission control module (TCM) temperature sensor is located inside of the control solenoid valve assembly which has no serviceable parts.

The TCM monitors the TCM sensor for over temperature protection.

Conditions for Running the DTC

* Ignition voltage is between 8.6 volts or greater.

* The TCM temperature is between 0掳C (32掳F) and 170掳C (338掳F) for 0.25 seconds.

* DTC P0634 and has not set this ignition.

Conditions for Setting the DTC

Condition 1

The TCM has detected an internal temperature condition greater than 142掳C (288掳F) for 5 seconds.

Condition 2

Ignition voltage is equal to or greater than 18 volts and the TCM temperature is greater than 50掳C (122掳F) for 2 seconds.

Action Taken When the DTC Sets

* DTC P0634 is a Type A DTC.

* The TCM shifts to a default gear, shuts down, and turns OFF.

* The TCM disables TAP shift operation.

* The TCM enables torque management.

Conditions for Clearing the DTC

DTC P0634 is a Type A DTC.

Diagnostic Aids

During a road test, the TCM temperature should steadily increase to a normal operating temperature, then stabilize.

Reference Information

Description and Operation

Electronic Component Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and

Operation/6L45/6L50/6L80/6L90 - Automatic Transmission/Electronic Component Description)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Circuit/System Verification

Note: If DTC P0218 is set, diagnose that DTC first.

1. Perform the Transmission Fluid Level and Condition Check (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing

and Inspection/Initial Inspection and Diagnostic Overview/6L45/6L50/6L80/6L90 - Automatic Transmission/Transmission Fluid Level and

Condition Check) to verify correct fluid level and condition.