Friday, November 6, 2020

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1910

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1910

* The ignition is ON

* DTCs P181C-P181F, P1824, P182A-P182F, P183A-P183E, P1838, P1839, P184A, or P184B are not set.

Conditions for Setting the DTC

The IMS Direction State does not match the IMS Range State.

Action Taken When the DTC Sets

DTC P183F is a Type A DTC.

Conditions for Clearing the DTC

DTC P183F is a Type A DTC.

Diagnostic Aids

* The direction IMS assembly can be damaged by electric current exceeding 25 mA. Test the IMS assembly for an open condition whenever a

short to voltage condition is observed.

* The direction IMS is a non-serviceable part of the manual shift shaft position switch.

Reference Information

Schematic Reference

Hybrid Controls Schematics ()

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Special Tools

* DT-47825-10 Jumper Harness

* DT-48493 Jumper Harness

Circuit/System Verification

1. Clear the DTC information.

2. Turn the ignition OFF for 1 minute.

3. Turn the ignition ON.

4. Test for correct operation of the direction and range IMS switch circuits in every gear selection. Hold the selector in each gear position for at

least 2 seconds. Refer to Typical Scan Tool Data.

瀚慖f the Direction IMS operation does not match the logic table proceed with Circuit/System Testing.

瀚慖f the IMS A/B/C/P operation does not match the logic table proceed to DTC P1824, P182A-P182F, P1838, or P1839 ( See: P Code

Charts/P1824).

5. Retest for DTC P183F

瀚慖f the DTC resets, program the PIM with the latest software version and recheck for DTCs. If the DTC resets after programming or if the

PIM already contains the latest software version, replace the PIM.

Circuit/System Testing

No comments:

Post a Comment