2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2195
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Important: Because of normal system communications between the TDM and ECM, any theft deterrent B-codes must be diagnosed prior
to the diagnosis of P-codes.
DTC P0633 will clear upon a successful engine start. Any malfunction that will cause a no-start condition will prevent DTC P0633 from
clearing. Prior to diagnosing DTC P0633, ensure that all power moding and engine control systems are operating properly and all
conditions that may cause a no-start have been corrected.
1. Ignition in the CRANK position, verify the scan tool Ignition Run/Crank parameter is Active.
瀚慖f not the specified value, refer to Power Mode Mismatch (See: Power and Ground Distribution/Testing and Inspection/Symptom
Related Diagnostic Procedures/Power Mode Mismatch).
2. Perform the 10-Minute Immobilizer Relearn procedure. Refer to Immobilizer System Component Programming (See: Accessories and
Optional Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and Relearning). The ECM should successfully
complete the password learn and the vehicle should start.
瀚慖f the ECM does not complete the learn or vehicle starting remains disabled, replace the ECM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming
2ML70 - Automatic Transmission
DTC P0634
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P0634
- Transmission Control Module (TCM) Overtemperature
Diagnostic Fault Information
No comments:
Post a Comment