Tuesday, October 27, 2020

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1670

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1670

3. Reconnect the 12V battery. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and Charging/Battery/Battery

Cable/Negative/Service and Repair/Battery Negative Cable Disconnection and Connection).

4. Ignition ON, retest for DTC P16F5.

瀚慖f the DTC resets, program the PIM with the latest software version and recheck for DTCs. If the DTC resets after programming or if the

PIM already contains the latest software version, replace the PIM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for PIM replacement, setup, and programming.

P16F6

DTC P16F6

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC P16F6

- Control Module Range State Command

Circuit/System Description

This diagnostic applies to internal microprocessor integrity conditions within the hybrid powertrain control module (HPCM). The HPCM monitors

its ability to read and write to the memory. The HPCM processor monitors the data to verify that the commanded range state calculation is correct.

Conditions for Running the DTC

* The control module runs the program to detect an internal fault when the key is ON.

* Ignition voltage is 8-18V.

Conditions for Setting the DTC

The control module has detected the commanded transmission range state is not correct based upon internal calculations or by a comparison to

input or output torque conditions.

Action Taken When the DTC Sets

* DTC P16F6 is a Type A DTC.

* The HPCM commands the battery energy control module (BECM) to open the high voltage contactor relays.

Conditions for Clearing the DTC

DTC P16F6 is a Type A DTC.

Reference Information

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Circuit/System Verification

1. Clear the DTC information.

2. Ignition OFF for 1 minute.

3. Ignition ON.

4. Retest for DTC P16F6.

Circuit/System Testing

No comments:

Post a Comment