2010 Cadillac Truck SRX AWD V6-3.0L Page 592

2010 Cadillac Truck SRX AWD V6-3.0L Page 592

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, command the LED Backlighting ON and OFF with a scan tool. The ignition switch halo lamp should turn ON and OFF when

changing between the commanded states.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the S38 ignition mode switch.

2. Ignition OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down. Test for less than 10 ohm

between the ground circuit terminal 4 and ground.

瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.

3. Connect a test lamp between the control circuit terminal 8 and the ground circuit terminal 4.

4. Command the LED Backlighting ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the

commanded states.

瀚慖f the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 BCM.

瀚慖f the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace

the K9 BCM.

5. If all circuits test normal, test or replace the S38 ignition mode switch.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Ignition and Start Switch Replacement (See: Powertrain Management/Ignition System/Sensors and Switches - Ignition System/Ignition

Switch/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, programming and setup

B2699

DTC B2575 or B2699

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC B2575 01

- Left Headlamp Control Circuit Short to Battery

DTC B2575 02

- Left Headlamp Control Circuit Short to Ground

DTC B2575 04

- Left Headlamp Control Circuit Open

DTC B2699 01

- Right Headlamp Control Circuit Short to Battery

DTC B2699 02

- Right Headlamp Control Circuit Short to Ground

DTC B2699 04

- Right Headlamp Control Circuit Open