Monday, September 14, 2020

2010 Cadillac Truck SRX AWD V6-3.0L Page 1507

2010 Cadillac Truck SRX AWD V6-3.0L Page 1507



P0454



If, during the engine-off natural vacuum small leak test, P0442, the ECM detects an abrupt fuel tank pressure signal change, other than a refueling



event, this DTC will set. An abrupt change is defined as a change of 0.45 inch H2O in the span of 1 second.



Action Taken When the DTC Sets



* DTCs P0451 and P0454 are Type A DTCs.



* DTCs P0452 and P0453 are Type B DTCs.



Conditions for Clearing the MIL/DTC



* DTCs P0451 and P0454 are Type A DTCs



* DTCs P0452 and P0453 are Type B DTCs



Diagnostic Aids



P0451 and P0454



* A restriction in the EVAP canister or vent lines could prevent fuel vapor pressure from bleeding off fast enough. If the vent system cannot



bleed off pressure fast enough, the re-zero procedure may not complete successfully, which could cause this code to set.



* Ensure that the reference port on the fuel tank pressure sensor is unobstructed.



* An fuel tank pressure sensor that is skewed or does not have a linear transition from low to high may cause this code to set. Scan tool output



controls, snapshot, and plot functions can help detect erratic sensor response. To test the sensor signal under vacuum conditions, use the



Quick Snapshot and the Purge/Seal functions to capture data while commanding purge to 20 percent, then plot the data to look for erratic



sensor operation. A similar test can be done for the pressure side of the sensor operation by applying pressure with the J 41413-200 - EEST



while taking a snapshot.



Reference Information



Schematic Reference



Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics



(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Special Tools



J 41413-200 - Evaporative Emission System Tester (EEST)



Circuit/System Verification



1. Remove the fuel cap.



2. Ignition ON, engine OFF.



3. Observe the Fuel Tank Pressure Sensor parameter with a scan tool.



4. The Fuel Tank Pressure Sensor parameter should be 1.3-1.7 V.



Circuit/System Testing



1. Ignition OFF, disconnect the harness connector at the B150 fuel tank pressure sensor.



2. Ignition OFF, test for less than 5 ohm of resistance between the low reference circuit terminal 2 and ground.

No comments:

Post a Comment