2010 Cadillac Truck SRX AWD V6-3.0L Page 374

2010 Cadillac Truck SRX AWD V6-3.0L Page 374

瀚慖f the test lamp does not illuminate, test the 12 volt referance circuit for a short to ground or an open/high resistance. If the circuit tests

normal test or replace the K33 HVAC control module.

Actuator Malfunction

1. Ignition OFF, disconnect the X3 and X4 harness connector at the K33 HVAC Control Module.

2. Ignition ON, test for 80-200 ohm between the 12 V reference voltage circuit terminal 15 X3 and each control circuit terminal of the

appropriate actuator.

瀚慖f less than the specified range, test for the 12 V reference voltage circuit and the control circuit for a short circuit. If the circuits test

normal, replace the appropriate actuator.

瀚慖f greater than the specified range, test the 12 V reference voltage circuit and the control circuit for an open/high resistance. If the circuits

test normal, replace the appropriate actuator.

3. If all circuits test normal, replace the K33 HVAC Control Module

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* HVAC Component Replacement Reference (See: Heating and Air Conditioning/Service and Repair/Removal and Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for HVAC control module replacement, setup, and

programming

B0418

DTC B0223, B022A, B0233, B023A, B0408, B0418, B0428, or B3531

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC B0223 01

- Recirculate Position Command 1 Circuit Short to Battery

DTC B0223 06

- Recirculate Position Command 1 Circuit Low Voltage/Open

DTC B022A 01

- Recirculate Position Command 2 Circuit Short to Battery

DTC B022A 06

- Recirculate Position Command 2 Circuit Low Voltage/Open

DTC B0233 01

- Air Flow Control Circuit Short to Battery

DTC B0233 06

- Air Flow Control Circuit Low Voltage/Open

DTC B023A 02

- HVAC Actuators Supply Voltage Short to Ground

DTC B0408 01

- Main Temperature Control Circuit Short to Battery

DTC B0408 06

- Main Temperature Control Circuit Low Voltage/Open

DTC B0418 01

- Right Temperature Control Circuit Short to Battery