2010 Cadillac Truck SRX AWD V6-3.0L Page 305

2010 Cadillac Truck SRX AWD V6-3.0L Page 305

Circuit/System Description

The body control module (BCM) supplies a reference voltage to the backlight dimmer switch, which is part of the headlamp switch. When the

backlight dimmer switch is placed in a desired brightness position, reference voltage is applied through the backlight dimmer switch rheostat to the

BCM. The BCM interprets this voltage signal, then applies a pulse width modulated (PWM) voltage to the LED dimming supply circuit to all

related interior lamps, illuminating them to the desired level of brightness.

Conditions for Running the DTC

The ignition is ON. Parklamps are illuminated.

Conditions for Setting the DTC

The BCM detects the instrument panel dimmer switch is ON for greater than 60 seconds.

Action Taken When the DTC Sets

The BCM will not dim or illuminate any LED backlighting supplied by the backlight lamp control circuits.

Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.

* A history DTC will clear once 100 consecutive malfunction ignition cycles have occurred.

Reference Information

Schematic Reference

Interior Lights Dimming Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System Diagram/Interior Lights Dimming

Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Interior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Interior Lighting Systems)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, switch ON exterior lighting, vary the interior backlight from dim to full bright by using the dimmer switch. The interior backlighting

should dim and then become full bright.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the S30 Headlamp Switch.

2. Ignition OFF, test for less than 5 ohm between the low reference circuit terminal 6 and ground.

瀚慖f greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K9

Body Control Module.

3. Ignition ON, test for 4.8-5.2 V between the 5 V reference circuit terminal 1 and ground.

瀚慖f less than the specified range, test the 5 V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal,

replace the K9 Body Control Module.

瀚慖f greater than the specified range, test the 5 V reference circuit for a short to voltage. If the circuit tests normal, replace the K9 Body