Wednesday, September 16, 2020

2010 Cadillac Truck SRX AWD V6-3.0L Page 688

2010 Cadillac Truck SRX AWD V6-3.0L Page 688



- Windshield Wiper High Speed Relay Circuit Open



Diagnostic Fault Information



Circuit/System Description



The body control module (BCM) controls the windshield wiper motor based on input from the windshield wiper/washer switch. The BCM monitors



the wiper/washer switch through two separate signal circuits and a ground circuit. The windshield wiper switch high signal circuit is used to



determine high speed wiper operation, the windshield wiper switch low signal is used to determine low speed, intermittent, and mist operation



through the use of a resistor ladder, and windshield washer switch signal circuit is used to determine washer operation.



The BCM controls the windshield wiper motor through two output controls, controlling two relays which determine the desired wiper speed, high



or low.



Conditions for Running the DTC



* The DTC runs only when a wiper output is actively being requested by the BCM.



* The system voltage is between 9-16 V.



Conditions for Setting the DTC



* A short to ground is detected in the Front Wiper Relay control circuit or in the High Speed Relay control circuit.



* A short to voltage or an open/high resistance is detected in the High Speed Relay control circuit.



Action Taken When the DTC Sets



The BCM will not activate the wiper output.



Conditions for Clearing the DTC



* A current DTC will clear when the condition for setting the fault is no longer present.



* A history DTC will clear after 50 consecutive ignition cycles without a fault present.



Reference Information



Schematic Reference



Wiper/Washer Schematics (See: Wiper and Washer Systems/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Wiper/Washer System Description and Operation (See: Wiper and Washer Systems/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

No comments:

Post a Comment