2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 419

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 419

Action Taken When the DTC Sets

The radio sets the DTC and defaults the video display to normal mode.

Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.

* A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.

Reference Information

Schematic Reference

Video System Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical Diagrams/Video System Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Video Entertainment System Description and Operation (Non-Headrest DVD Systems) (See: Accessories and Optional Equipment/Description

and Operation/Video Entertainment System Description and Operation (Non-Headrest DVD Systems))Video Entertainment System Description

and Operation (Dual Headrest DVD Systems) (See: Accessories and Optional Equipment/Description and Operation/Video Entertainment System

Description and Operation (Dual Headrest DVD Systems))

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the rear video display.

2. Ignition ON, test for 100-300 Hz at the control circuit terminal 10.

瀚慖f not within the specified range, test the control circuit for a short to voltage, short to ground, or an open/high resistance. If the circuit

tests normal, replace the radio.

3. If all circuits test normal, replace the rear video display.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Video Display Replacement (Second Row) (See: Accessories and Optional Equipment/Entertainment Systems/Television / Monitor/Service

and Repair/Video Display Replacement (Second Row))Video Display Replacement (Third Row) (See: Accessories and Optional

Equipment/Entertainment Systems/Television / Monitor/Service and Repair/Video Display Replacement (Third Row))

* Control Module References (See: Testing and Inspection/Programming and Relearning) for Radio replacement, setup, and programming

B1289

DTC B1289

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.