2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 474

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 474

B1600

An improper voltage level is detected on the driver/passenger mirror motor vertical control circuit while the mirror is being commanded.

B1605

An improper voltage level is detected on the driver/passenger mirror motor horizontal control circuit while the mirror is being commanded.

Action Taken When the DTC Sets

Mirror movement is suspended as long as the fault is present.

Conditions for Clearing the DTC

* A current DTC will clear when the fault is no longer present.

* A history DTC will clear after 40 fault free ignition cycles.

Reference Information

Schematic Reference

Outside Rearview Mirror Schematics (See: Body and Frame/Mirrors/Diagrams/Electrical Diagrams/Outside Rearview Mirror Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Outside Mirror Description and Operation (Heated Mirrors) (See: Body and Frame/Mirrors/Description and Operation/Outside Mirror Description

and Operation (Heated Mirrors))Outside Mirror Description and Operation (Power Mirrors) (See: Body and Frame/Mirrors/Description and

Operation/Outside Mirror Description and Operation (Power Mirrors))

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool References

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Command the left and right outside mirror to move up, down, left and right using the mirror directional switch. The mirror should move in the

commanded direction.

Circuit/System Testing

1. Ignition OFF, disconnect the X3 harness connector at the appropriate door module.

2. Ignition ON, verify a test lamp does not illuminate between the following control circuit terminals and ground:

* Control circuit terminal 1

* Control circuit terminal 2

* Control circuit terminal 6

瀚慖f the test lamp illuminates, test the appropriate control circuit for a short to voltage.

3. Ignition OFF, test for infinite resistance between the following control circuits and ground:

* Control circuit terminal 1

* Control circuit terminal 2

* Control circuit terminal 6

瀚慖f less the specified value, test the appropriate control circuit for a short to ground.

4. Test for 40-100 ohms between the control circuit terminal 1 and the control circuit terminal 6.