2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 476

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 476

The heated mirror will be disabled.

Conditions for Clearing the DTC

* A current DTC will clear when the fault is no longer present.

* A history DTC will clear after 40 fault free ignition cycles.

Reference Information

Schematic Reference

Outside Rearview Mirror Schematics (See: Body and Frame/Mirrors/Diagrams/Electrical Diagrams/Outside Rearview Mirror Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Outside Mirror Description and Operation (Heated Mirrors) (See: Body and Frame/Mirrors/Description and Operation/Outside Mirror Description

and Operation (Heated Mirrors))Outside Mirror Description and Operation (Power Mirrors) (See: Body and Frame/Mirrors/Description and

Operation/Outside Mirror Description and Operation (Power Mirrors))

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool References

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information.

Circuit/System Verification

Ignition ON, press the rear window defogger switch. The rear window defogger and both heated mirrors should become warm.

Circuit/System Testing

1. Ignition OFF, disconnect the X3 harness connector at the appropriate door module.

2. Ignition ON, verify a test lamp does not illuminate between the control circuit terminal 7 and ground.

瀚慖f the test lamp illuminates, test the control circuit for a short to voltage.

3. Ignition OFF, test for infinite resistance between the control circuit terminal 7 and ground.

瀚慖f less than the specified value, test the control circuit for a short to ground. If the circuit tests normal, test or replace the applicable

rearview mirror face.

4. Test for 5-10 ohms of resistance between the control circuit terminal 7 and the low reference circuit terminal 3.

瀚慖f not within the specified range, test the control circuit and the low reference circuit for an open/high resistance. If the circuits test

normal, test or replace the appropriate rearview mirror face.

5. If all circuits test normal, test or replace the door module.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Outside Rearview Mirror Glass Replacement (See: Body and Frame/Mirrors/Service and Repair/Outside Rearview Mirror Glass

Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for DDM or PDM replacement, setup and