2010 Cadillac Truck Escalade RWD V8-6.2L Page 2474

2010 Cadillac Truck Escalade RWD V8-6.2L Page 2474

Conditions for Running the DTC

P1516 and P2101

* DTC P0606 and P1682 is not set.

* The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.

* The engine is running or the following conditions are met:

- The engine is not running.

- The ignition voltage is greater than 11 V.

- The TAC system is not in the Battery Saver mode.

- The ECM is commanding the throttle.

- The ECM has learned the minimum throttle position.

* DTC P1516 and P2101 run continuously when the above conditions are met.

P2119

* The ignition is ON.

* The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.

* The TP sensor 1 voltage is greater than 1.7 V

* The ECM is not commanding the throttle blade.

* DTC P2119 runs continuously when the above conditions are met.

P2176

* DTCs P0120, P0121, P0122, P0123, P0220, P0222, P0223, or P1682 is not set.

* The ignition is ON.

* The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.

* The ECM enable the minimum throttle learn procedure.

* DTC P2176 run continuously when the above conditions are met.

Conditions for Setting the DTC

P1516

The actual throttle position does not match the predicted throttle position for greater than 1 s.

P2101

The actual throttle position does not match the predicted throttle position for greater than 1 s.

P2119

The ECM detects that the throttle blade did not return to the default position when the TAC motor is de-energized for greater than 1 s.

P2176

The ECM detects that both throttle position (TP) sensors were greater than a predetermined voltage during the minimum throttle learn procedure for

greater than 2 s.

Action Taken When the DTC Sets

P1516, P2101, and P2176

* DTCs P1516, P2101, and P2176 are Type A DTCs.

* The control module commands the TAC system to operate in the Reduced Engine Power mode.

* A message center or an indicator displays Reduced Engine Power.

* Under certain conditions, the control module commands the engine OFF.

P2119

* DTC P2119 is a Type C DTC.

* The driver information center, if equipped, may display a message.

Conditions for Clearing the MIL/DTC

* DTCs P1516, P2101, and P2176 are Type A DTCs.

* DTC P2119 is a Type C DTC.

Diagnostic Aids

* If the Throttle Sweep Test is not available on the scan tool, observe the scan tool TAC Motor parameter while performing the following tests: