2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1579

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1579

4. Ignition ON, test for 8.3-9.3 volts between the ISS voltage circuit terminal A, on the TCM assembly, and ground.

瀚慖f not within the specified range, replace the control solenoid valve assembly. Refer to Control Solenoid Valve and Transmission Control

Module Assembly Replacement (See: Powertrain Management/Transmission Control Systems/Actuators and Solenoids - Transmission

and Drivetrain/Actuators and Solenoids - A/T/Shift Solenoid/Service and Repair).

5. Perform the Control Solenoid Valve and Transmission Control Module Assembly Input Shaft Speed/Output Shaft Speed Input Test (See:

Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General

Diagnostics/6T70/6T75 - Automatic Transmission/Control Solenoid Valve and Transmission Control Module Assembly Input Shaft

Speed/Output Shaft Speed Input Test).

6. Inspect the reluctor for damage or misalignment. Repair or replace as necessary.

7. If all of the above test normal, replace the input speed sensor.

Repair Instructions

Important:

* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and

Inspection/Programming and Relearning) following all transmission related repairs.

Input Speed Sensor Replacement (See: Powertrain Management/Transmission Control Systems/Sensors and Switches - Transmission and

Drivetrain/Sensors and Switches - A/T/Transmission Speed Sensor/Service and Repair/Input Speed Sensor Replacement)

* Before replacing the TCM, perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See:

Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General

Diagnostics/6T70/6T75 - Automatic Transmission/Control Solenoid Valve and Transmission Control Module Assembly Inspection).

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid valve assembly replacement, setup,

and programming

6T70/6T75 - Automatic Transmission

DTC P0716 or P0717

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0716

- Input Speed Sensor Performance

DTC P0717

- Input Speed Sensor Circuit Low Voltage

Diagnostic Fault Information

Typical Scan Tool Data

Circuit/System Description