2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1650
Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General
Diagnostics/6T70/6T75 - Automatic Transmission/Control Solenoid Valve and Transmission Control Module Assembly Inspection).
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Control Valve Lower Body and Upper Body Replacement (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Valve
Body/Service and Repair/6T70/6T75 - Automatic Transmission/Control Valve Lower Body and Upper Body Replacement)
* Low and Reverse Clutch and 1-2-3-4 Clutch Plate Removal (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service
and Repair/Overhaul/8. Low and Reverse Clutch and 1-2-3-4 Clutch Plate Removal) and 3-5-Reverse and 4-5-6 Clutch Housing Disassemble
(See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Overhaul/41. 3-5-Reverse and 4-5-6 Clutch
Housing Disassemble)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid valve assembly replacement,
setup, and programming
P0798
DTC P0798 or P0969-P0971
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0798
- Pressure Control Solenoid Valve 2 System Performance
DTC P0969
- Pressure Control Solenoid Valve 2 System Performance
DTC P0970
- Pressure Control Solenoid Valve 2 Control Circuit Low Voltage
DTC P0971
- Pressure Control Solenoid Valve 2 Control Circuit High Voltage
Diagnostic Fault Information
Typical Scan Tool Data
Circuit/System Description
The shift control solenoid (SLC2) is installed on the front valve body. The solenoid linearly control hydraulic pressure in response to signals output
from the transmission control module TCM. Through this, the SLC2 controls operating hydraulic pressure to the clutch 2 for smooth shifting.
According to each shift control solenoid assembly, the transmission shifts from 1st gear into 6th gear and vice versa. As a fail-safe function, if any
shift control solenoid assembly abnormality occurs, the TCM will disable the current to the solenoids.
Conditions for Running the DTC
No comments:
Post a Comment