Wednesday, March 11, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1567

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1567



瀚慖f less than the specified range, replace the wiring harness.



5. Test for the resistance between the B13 Automatic Transmission Fluid Temperature Sensor signal circuit terminal 7 X2 and the low reference



circuit terminal 8 X2. Refer to Transmission Fluid Temperature Sensor Specifications (See: Transmission and Drivetrain/Automatic



Transmission/Transaxle/Specifications/Pressure, Vacuum and Temperature Specifications) for the resistance values.



瀚慖f not within the specified range, replace the wiring harness.



6. If the circuit test normal, replace the K71 Transmission Control Module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Wiring harness-Refer to Automatic Transmission Wiring Harness Replacement (See: Transmission and Drivetrain/Automatic



Transmission/Transaxle/Wiring Harness/Service and Repair) for replacement.



* TCM-Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for replacement, setup, and



programming.



* Perform the Transmission Adaptive Functions (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and



Operation/AF40-6 - Automatic Transmission/Transmission Adaptive Functions).



6T70/6T75 - Automatic Transmission



DTC P0711, P0712, or P0713



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0711



- Transmission Fluid Temperature (TFT) Sensor Performance



DTC P0712



- Transmission Fluid Temperature (TFT) Sensor Circuit Low Voltage



DTC P0713



- Transmission Fluid Temperature (TFT) Sensor Circuit High Voltage



Circuit/System Description



The transmission fluid temperature (TFT) sensor is located inside of the transmission control module (TCM) assembly which has no serviceable



components. The TFT sensor provides transmission fluid temperature to the TCM. This fault is handled inside the TCM and no external circuits are



involved.



Conditions for Running the DTC



P0711



* No DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207,



P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0658, P0668, P0669, P06AD, P06AE, P0711,



P0712, P0713, P0716, P0717, P0722, P0723, P0962, P0963, P0966, P0967, P0970, P0971, P215C, P2720, P2721, P2729, or P2730.



* The engine speed is greater than 400 RPM for 5 seconds.



* The ignition voltage is 8.6 volts or greater.



* Brake torque is not active.



* The engine torque signal is valid.



* The throttle position signal is valid.



P0712



* No DTCs P0712, P0716, P0717, P0722, or P0723.



* The engine speed is greater than 400 RPM for 5 seconds.



* The ignition voltage is 8.6 volts or greater.

No comments:

Post a Comment