2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1569

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1569

2. Operate the vehicle at 64 km/h (40 mph) for 10 minutes. Monitor the TCM Temperature, TCM Power up Temperature, and the Trans. Fluid

Temp. parameters with a scan tool. The TCM Temperature and the Trans. Fluid Temp. parameters should be within 25掳C (45掳F) of each

other, and the Trans. Fluid Temp. and TCM Power up Temperature parameters should be within 25掳C (45掳F) of each other.

瀚慖f both are greater than the specified range, replace the control solenoid valve assembly.

3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the

conditions that you observed from the Freeze Frame/Failure Records data.

Repair Instructions

Important:

* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and

Inspection/Programming and Relearning) following all transmission related repairs.

* Before replacing the TCM, perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See:

Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General

Diagnostics/6T70/6T75 - Automatic Transmission/Control Solenoid Valve and Transmission Control Module Assembly Inspection).

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid valve assembly replacement, setup,

and programming

AF40-6 - Automatic Transmission

DTC P0711, P0712, or P0713

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0711

- Transmission Fluid Temperature Sensor Performance

DTC P0712

- Transmission Fluid Temperature Sensor Circuit Low Voltage

DTC P0713

- Transmission Fluid Temperature Sensor Circuit High Voltage

Diagnostic Fault Information

Typical Scan Tool Data

Circuit/System Description

The automatic transmission fluid temperature sensor provides transmission fluid temperature to the transmission control module (TCM). The TCM