2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1421
DTC P0562
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P0562
- System Voltage Low
Diagnostic Fault Information
Circuit/System Description
The following control modules monitor the system voltage to ensure that the voltage stays within the proper range:
* Engine control module
* Fuel pump control module
* Transmission control module
Damage to components, and incorrect data may occur when the voltage is out of range.
Conditions for Running the DTC
Engine Control Module
The system voltage is between 9.5-18 V.
Fuel Pump Control Module
The engine is running.
Transmission Control Module
* Engine speed is 1200 RPM or greater.
* The system voltage is between 8.6-18 V.
Conditions for Setting the DTC
Engine Control Module
The engine control module detects a system voltage below 10 V for 5 seconds.
Fuel Pump Control Module or Transmission Control Module
The module detects a system voltage below 9 V for 4 seconds.
Action Taken When the DTC Sets
DTC P0562 is a C type DTC.
Conditions for Clearing the DTC
DTC P0562 is a C type DTC.
Reference Information
Schematic Reference
* Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls
No comments:
Post a Comment