Tuesday, March 3, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1980

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1980



DTC P2728-P2730



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P2728



- Clutch Pressure Control (PC) Solenoid 5 System Performance



DTC P2729



- Clutch Pressure Control (PC) Solenoid 5 Control Circuit Low Voltage



DTC P2730



- Clutch Pressure Control (PC) Solenoid 5 Control Circuit High Voltage



Diagnostic Fault Information



Circuit/System Description



The clutch pressure control (PC) solenoid 5 is part of the control solenoid valve assembly which has no serviceable components. The normally low



PC solenoid 5 regulates and directs oil pressure to the 1-2-3-4 clutch regulator valve and 1-2-3-4 clutch boost valve. Increasing PC solenoid 5



pressure increases pressure to the 1-2-3-4 clutch. The TCM varies the current to the PC solenoid 5 through a low side driver. Increasing the current



to PC solenoid 5 increases oil pressure by closing OFF the solenoid exhaust port. Decreasing the current to PC solenoid 5 decreases oil pressure by



opening the exhaust port. PC solenoid 5 power is supplied by the TCM through a high side driver (HSD). The HSD protects the circuit and



components from excessive current flow. If excessive current flow is detected, the HSD will turn OFF. When the fault is corrected, the HSD will



reset.



Conditions for Running the DTC



P2728



* DTC P2728 has not set this ignition cycle.



* The engine speed is 400 RPM or greater for 5 seconds.



* The ignition voltage is 8.6 volts or greater.



P2729



* DTC P2729 has not set this ignition cycle.



* The engine speed is 400 RPM or greater for 5 seconds.



* The ignition voltage is 8.6 volts or greater.



P2730



* DTC P2730 has not set this ignition cycle.



* The engine speed is 400 RPM or greater for 5 seconds.



* The ignition voltage is 8.6 volts or greater.



Conditions for Setting the DTC



P2728



The TCM detects an internal electrical performance malfunction of the clutch PC solenoid 5 control circuit where the measured clutch PC solenoid



5 current does not equal the commanded clutch PC solenoid 5 current for 5 seconds.



P2729



The TCM detects a short to ground on the clutch PC solenoid 5 control circuit for 1 second.



P2730



The TCM detects an open or short to voltage on the clutch PC solenoid 5 control circuit for 1 second.

No comments:

Post a Comment