Monday, March 9, 2020

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2917

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2917

* The engine run time is greater than 5 seconds.

* The vehicle speed is less than 200 km/h (124 mph) for 5 seconds.

* The system voltage is 11-18 V.

Conditions for Setting the DTC

P2719

The transmission control module detects an internal electrical performance malfunction of the clutch pressure control solenoid 4 control circuit

when the actual 1-3 clutch pressure does not equal the commanded 1-3 clutch pressure for 5 seconds.

P2720

The transmission control module detects an internal low voltage electrical malfunction of the clutch pressure control solenoid 4 control circuit for

500 milliseconds.

P2721

The transmission control module detects an internal high voltage electrical malfunction of the clutch pressure control solenoid 4 control circuit for

500 milliseconds.

Action Taken When the DTC Sets

* P2719 is a Type B DTC.

* P2720 and P2721 are Type A DTCs.

* The transmission control module defaults the transmission to a limited shift pattern utilizing 2 forward gears and reverse based on the default

detected.

* The transmission control module commands maximum line pressure.

* The transmission control module freezes transmission adaptive functions.

Conditions for Clearing the DTC

* P2719 is a Type B DTC.

* P2720 and P2721 are Type A DTCs.

Diagnostic Aids

When attempting to set solenoid electrical DTCs, ensure the transmission control module is warmed up and the transmission is operated long

enough to ensure a 3掳C (5掳F) increase in TCM temperature. This will place the transmission control module under the optimal conditions to test

solenoid electrical DTCs.

Reference Information

Schematic Reference

Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Circuit/System Verification

1. Engine ON, verify the transmission fluid temperature is between 50-80掳C (122-176掳F).

2. Operate the vehicle long enough to verify at least a 3掳C (5掳F) rise in the TCM temperature parameter, then operate the vehicle in Park for 5

No comments:

Post a Comment