Thursday, March 5, 2020

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2823

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2823

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Important: Perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See: Transmission and

Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/2ML70 - Automatic

Transmission/Control Solenoid Valve and Transmission Control Module Assembly Inspection) for the following components before replacing

the components.

* Manual Shift Shaft Position Switch Replacement (See: Powertrain Management/Computers and Control Systems/Sensors and Switches -

Computers and Control Systems/Transmission Position Sensor/Switch/Service and Repair/2ML70 - Automatic Transmission) for IMS

replacement.

* Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid (w/body and TCM) valve

assembly replacement, setup, and programming.

* Wiring Harness Replacement (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Wiring Harness/Service and

Repair/Wiring Harness Replacement) for automatic transmission control wiring harness extension harness assembly replacement.

P1915

DTC P182E or P1915

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions)provides an overview of each diagnostic category.

DTC Descriptors

DTC P182E

- Internal Mode Switch - Invalid Range

DTC P1915

- Internal Mode Switch Does Not Indicate Park/Neutral (P/N) During Start

Diagnostic Fault Information

No comments:

Post a Comment