Sunday, March 8, 2020

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2902

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2902

Conditions for Running the DTC

* DTC P018B, P018C, P018D, P0231, P0232, P023F, P064A, P1255 or P06A6 are not active.

* DTC P0641 has not failed this ignition cycle.

* Fuel pump control is enabled and the fuel pump control state is normal.

* The system voltage is greater than 11 V.

* The engine has been running for more than 30 seconds.

Conditions for Setting the DTC

This DTC sets when the fuel pump control module detects a predetermined fuel pressure performance degradation between the desired fuel rail

pressure and the current fuel rail pressure.

Action Taken When the DTC Sets

DTC P2635 is a Type A DTC.

Conditions for Clearing the DTC

DTC P2635 is a Type A DTC.

Diagnostic Aids

Using the Failure Records data may help locate an intermittent condition. If you cannot duplicate the DTC, the information in the Failure Records

can help determine how many miles since the DTC set. The Fail Counter and Pass Counter can help determine how many ignition cycles that the

diagnostic test reported a pass and/or a fail.

Reference Information

Schematic Reference

Engine Controls Schematics (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Fuel System Description (See: Powertrain Management/Computers and Control Systems/Description and Operation/Fuel System Description)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

1. Verify that DTCs P018B, P018C, P018D, P0231, P0232, or P023F are not set.

瀚慖f the DTCs are set, refer to DTC P018B-P018D (See: P Code Charts/P018B) or DTC P0231, P0232, or P023F (See: P Code

Charts/P0231).

2. Ignition OFF, disconnect the harness connector at the fuel tank pump module.

3. Ignition ON, test for less than 5.0 ohm between the fuel pump module low reference circuit terminal A and ground.

瀚慖f greater than the specified range, test the fuel pump module low reference circuit for a high resistance. If the circuit tests normal, replace

the fuel pump control module.

No comments:

Post a Comment