2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2802

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2802

DTC P1632

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC P1632

- Theft Deterrent Fuel Disable Signal Received

Circuit/System Description

The theft deterrent module (TDM) sends the prerelease password to the engine control module (ECM) via the serial data circuit. The ECM then

sends a challenge to the TDM. Both the ECM and TDM perform a calculation on this challenge. If the calculated response from the TDM equals

the calculation performed by the ECM, the ECM will allow vehicle starting.

Conditions for Running the DTC

Ignition is in the RUN position.

Conditions for Setting the DTC

A fuel disable signal from the TDM is received by the ECM.

Action Taken When the DTC Sets

* The security indicator will illuminate.

* Vehicle starting will be disabled.

Conditions for Clearing the DTC

* A current DTC P1632 will be when a valid calculation is received.

* A history DTC will be cleared after 40 malfunction-free ignition cycles or when a scan tool is used to clear DTCs.

Diagnostic Aids

The prerelease password sent to the ECM by the TDM is reliant on the communications between the transponder located in the vehicle key and the

TDM. Failure to establish communications or an interruption in the communications between the vehicle key and the TDM will cause the fuel

disable message to be sent and the setting of DTC B1632. DTC B3055 or B3060 will be set in the TDM. To properly diagnose DTC P1632, DTC

B3055 or B3060 must be diagnosed and corrected first.

Reference Information

Schematic Reference

Immobilizer Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Diagrams/Electrical Diagrams/Immobilizer

Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Immobilizer Description and Operation (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Description and

Operation/Immobilizer Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)