Tuesday, March 10, 2020

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2941

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2941

DTC P2728-P2730

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P2728

- Clutch Pressure Control (PC) Solenoid 5 System Performance

DTC P2729

- Clutch Pressure Control (PC) Solenoid 5 Control Circuit Low Voltage

DTC P2730

- Clutch Pressure Control (PC) Solenoid 5 Control Circuit High Voltage

Diagnostic Fault Information

Typical Scan Tool Data

Circuit/System Description

The clutch pressure control (PC) solenoid 5 is part of the control solenoid valve assembly which has no serviceable parts. The normally low PC

solenoid 5 regulates and directs oil pressure to the 1-2-3-4 clutch regulator valve and 1-2-3-4 clutch boost valve. Increasing PC solenoid 5 pressure

increases pressure to the 1-2-3-4 clutch. The TCM varies the current to the PC solenoid 5 through a low side driver. Increasing the current to PC

solenoid 5 increases oil pressure by closing OFF the solenoid exhaust port. Decreasing the current to PC solenoid 5 decreases oil pressure by

opening the exhaust port. PC solenoid 5 power is supplied by the TCM through a high side driver (HSD). The HSD protects the circuit and

components from excessive current flow. If excessive current flow is detected, the HSD will turn OFF. When the fault is corrected, the HSD will

reset.

Conditions for Running the DTC

P2728, P2729, or P2730

* DTCs P2728, P2729, or P2730 have not set this ignition.

* The ignition voltage is 8.6 volts or greater.

* The engine speed is 400 RPM or greater for 5 seconds.

* The clutch PC solenoid 5 is commanded ON.

Conditions for Setting the DTC

P2728

The TCM detects an internal electrical performance malfunction of the clutch PC solenoid 5 control circuit where the measured clutch PC solenoid

No comments:

Post a Comment