Monday, March 9, 2020

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2916

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2916

Drivetrain/Actuators and Solenoids - A/T/Shift Solenoid/Service and Repair).

2. Perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See: Transmission and Drivetrain/Automatic

Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/6L45/6L50/6L80/6L90 - Automatic

Transmission/Control Solenoid Valve and Transmission Control Module Assembly Inspection).

3. Place the Q8 control solenoid valve assembly on a clean work surface near the transmission assembly.

4. Connect DT-47825-10 - jumper harness between the vehicle wire harness electrical connector, and the Q8 control solenoid valve assembly

electrical connector.

5. Ignition ON, verify with a scan tool the following test status parameters display OK:

* Pressure Control Solenoid Valve 4 Performance Test Status

* Pressure Control Solenoid Valve 4 Control Circuit High Voltage Test Status

* Pressure Control Solenoid Valve 4 Control Circuit Low Voltage Test Status

瀚慖f any test status parameter displays Fault or Malfunction, replace the Q8 control solenoid valve assembly.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and

Inspection/Programming and Relearning) following all transmission related repairs.

* Replace the control solenoid valve assembly. Refer to Control Module References (See: Testing and Inspection/Programming and

Relearning) for replacement, setup, and programming.

2ML70 - Automatic Transmission

DTC P2719-P2721

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P2719

- Pressure Control (PC) Solenoid 4 System Performance

DTC P2720

- Pressure Control (PC) Solenoid 4 Control Circuit Low Voltage

DTC P2721

- Pressure Control (PC) Solenoid 4 Control Circuit High Voltage

Diagnostic Fault Information

Typical Scan Tool Data

Circuit/System Description

The clutch pressure control solenoid 4 is part of the control solenoid valve assembly and is not serviced separately. The transmission control

module supplies 12 volts to the clutch pressure control solenoid 4 through the high side driver 1 circuit. The transmission control module controls

the clutch pressure control solenoid 4 through the clutch pressure control solenoid 4 control circuit. The normally low clutch pressure control

solenoid 4 flows fluid to the 1-3 clutch when commanded ON and exhausts fluid when commanded OFF. The clutch pressure control solenoid 4

regulates the transmission fluid pressure to the 1-3 clutch.

Conditions for Running the DTC

No comments:

Post a Comment