Wednesday, March 11, 2020

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2978

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2978

* The engine speed is greater than 400 RPM.

* The ignition voltage is between 11-18 V.

* DTCs P3401, P3425, P3441, and P3449 run continuously when the above conditions are met.

Conditions for Setting the DTC

The ECM detects that the commanded state of the driver and the actual state of the control circuit do not match for greater than 5 s.

Action Taken When the DTC Sets

* DTCs P3401, P3425, P3441, and P3449 are Type B DTCs.

* The engine will return to V8 mode.

* The fuel injector will turn OFF for the cylinder that has a cylinder deactivation DTC set, resulting in an engine misfire.

Conditions for Clearing the DTC

DTCs P3401, P3425, P3441, and P3449 are Type B DTCs.

Diagnostic Aids

The valve lifter oil manifold solenoids are assigned to the following engine cylinders:

* Solenoid #1 = Cylinder #1

* Solenoid #2 = Cylinder #4

* Solenoid #3 = Cylinder #6

* Solenoid #4 = Cylinder #7

Reference Information

Schematic Reference

Engine Controls Schematics (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Cylinder Deactivation (Active Fuel Management) System Diagnosis (See: Powertrain Management/Computers and Control Systems/Testing and

Inspection/Component Tests and General Diagnostics/Cylinder Deactivation (Active Fuel Management) System Diagnosis)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Special Tools

EN-46999 Displacement On Demand Tester

For equivalent regional tools, refer to Special Tools (See: Powertrain Management/Computers and Control Systems/Tools and Equipment).

Circuit/System Verification

1. Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description ( See: Hybrid Drive

Systems/Description and Operation/Hybrid Modes of Operation).

2. Ignition ON, verify the scan tool hood position parameter displays Open.

瀚慖f the hood position does not display Open, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code

No comments:

Post a Comment