2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2860

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2860

瀚慖f less than the specified range, test the APP sensor 1 signal circuit for a short to ground or an open/high resistance. If the circuit tests

normal, replace the ECM.

6. Install a 3 A fused jumper wire between the APP sensor 2 signal circuit terminal B and the 5-volt reference circuit terminal D. Verify the scan

tool APP sensor 2 voltage parameter is greater than 4.8 V.

瀚慖f less than the specified range, test the APP sensor 2 signal circuit for an open/high resistance or short to ground. If the circuit tests

normal, replace the ECM.

7. If all circuits and connections test normal, test or replace the Accelerator Pedal Position Sensor.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Accelerator Pedal Position Sensor Replacement (See: Powertrain Management/Computers and Control Systems/Accelerator Pedal Position

Sensor/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming

P2135

DTC P0120, P0122, P0123, P0220, P0222, P0223, or P2135

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0120

- Throttle Position (TP) Sensor 1 Circuit

DTC P0122

- Throttle Position (TP) Sensor 1 Circuit Low Voltage

DTC P0123

- Throttle Position (TP) Sensor 1 Circuit High Voltage

DTC P0220

- Throttle Position (TP) Sensor 2 Circuit

DTC P0222

- Throttle Position (TP) Sensor 2 Circuit Low Voltage

DTC P0223

- Throttle Position (TP) Sensor 2 Circuit High Voltage

DTC P2135

- Throttle Position (TP) Sensor 1-2 Correlation

Diagnostic Fault Information

Typical Scan Tool Data