Monday, March 9, 2020

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2918

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2918

3. Engine ON, observe the scan tool Clutch PC 4 Sol. CKT Status parameter. The reading should display OK or Indeterminate.

瀚慖f the reading is not within the specified range, replace the Q8 control solenoid valve assembly.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for Q8 control solenoid valve assembly replacement,

setup, and programming.

2ML70 - Automatic Transmission

DTC P2719-P2721

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P2719

- Pressure Control (PC) Solenoid 4 System Performance

DTC P2720

- Pressure Control (PC) Solenoid 4 Control Circuit Low Voltage

DTC P2721

- Pressure Control (PC) Solenoid 4 Control Circuit High Voltage

Diagnostic Fault Information

Typical Scan Tool Data

Circuit/System Description

The clutch pressure control solenoid 4 is part of the control solenoid valve assembly and is not serviced separately. The transmission control

module supplies 12 volts to the clutch pressure control solenoid 4 through the high side driver 1 circuit. The transmission control module controls

the clutch pressure control solenoid 4 through the clutch pressure control solenoid 4 control circuit. The normally low clutch pressure control

solenoid 4 flows fluid to the 1-3 clutch when commanded ON and exhausts fluid when commanded OFF. The clutch pressure control solenoid 4

regulates the transmission fluid pressure to the 1-3 clutch.

Conditions for Running the DTC

* The engine run time is greater than 5 seconds.

* The vehicle speed is less than 200 km/h (124 mph) for 5 seconds.

* The system voltage is 11-18 V.

Conditions for Setting the DTC

P2719

The transmission control module detects an internal electrical performance malfunction of the clutch pressure control solenoid 4 control circuit

when the actual 1-3 clutch pressure does not equal the commanded 1-3 clutch pressure for 5 seconds.

No comments:

Post a Comment