2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2801

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2801

The theft deterrent module (TDM) sends the prerelease password to the engine control module (ECM) via the serial data circuit. The ECM then

sends a challenge to the TDM. Both the ECM and TDM perform a calculation on this challenge. If the calculated response from the TDM equals

the calculation performed by the ECM, the ECM will allow vehicle starting.

Conditions for Running the DTC

Ignition is in the ACCESSORY or RUN position.

Conditions for Setting the DTC

The ECM receives an incorrect prerelease password from the TDM.

Action Taken When the DTC Sets

* The security indicator will illuminate.

* Vehicle starting will be disabled.

Conditions for Clearing the DTC

* A current DTC P1631 will be when a correct fuel enable password is received.

* A history DTC will be cleared after 40 malfunction-free ignition cycles or when a scan tool is used to clear DTCs.

Reference Information

Schematic Reference

Immobilizer Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Diagrams/Electrical Diagrams/Immobilizer

Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Immobilizer Description and Operation (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Description and

Operation/Immobilizer Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Important: Because of normal system communications between the TDM and ECM, any theft deterrent B-codes must be diagnosed prior

to the diagnosis of P-codes.

Perform the 10-Minute Immobilizer Relearn procedure. Refer to Immobilizer System Component Programming (See: Accessories and Optional

Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and Relearning). The ECM should successfully complete the

password learn and the vehicle should start.

If the ECM does not complete the learn or vehicle starting remains disabled, replace the ECM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup and programming