2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2816

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2816

3. Connect the IMS harness connector to the control solenoid (w/body and TCM) valve assembly. Disconnect the IMS connector. The scan tool

IMS A/B/C/P parameter should display HI for all 4 signal circuits.

瀚慖f a signal circuit displays LOW, replace the IMS jumper harness.

4. Connect a 3-amp fused jumper wire between each transmission range signal circuit at the IMS connector harness and ground. With a scan

tool, ensure that each signal circuit displays LOW when connected to ground.

瀚慖f a signal circuit remains HI when connected to ground, replace the IMS harness.

瀚慖f a signal circuit other than the circuit being grounded displays LOW, replace the IMS harness.

瀚慖f all circuits test normal, replace the IMS.

Component Testing

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Important: Perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See: Transmission and

Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/2ML70 - Automatic

Transmission/Control Solenoid Valve and Transmission Control Module Assembly Inspection) for the following components before replacing

the components.

* Manual Shift Shaft Position Switch Replacement (See: Powertrain Management/Computers and Control Systems/Sensors and Switches -

Computers and Control Systems/Transmission Position Sensor/Switch/Service and Repair/2ML70 - Automatic Transmission) for IMS

replacement.

* Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid (w/body and TCM) valve

assembly replacement, setup, and programming.

* Wiring Harness Replacement (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Wiring Harness/Service and

Repair/Wiring Harness Replacement) for automatic transmission control wiring harness extension harness assembly replacement.

P1838

DTC P1824, P182A-P182F, P1838, or P1839

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.