Monday, February 10, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1469

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1469



P161C, or P2610 should not set.



2. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the



conditions that you observed from the Freeze Frame/Failure Records data.



Circuit/System Testing



1. Ignition ON, clear the DTC information with a scan tool. Observe the scan tool DTC information.



瀚慖f DTC P0602, P0610, P0614, P0630, P160D, P160E, or P161C failed this ignition, reprogram the K20 ECM. Refer to Control Module



References (See: Testing and Inspection/Programming and Relearning). If the DTC resets, replace the K20 ECM.



2. Observe the DTC information with a scan tool. Verify DTC P0603, P0604, P0605, P0606, P06D1, or P2610 does not set.



瀚慖f a DTC failed this ignition, replace the K20 ECM.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for engine control module replacement, setup, and



programming



P0614



DTC P0602-P0606, P0610, P0614, P0630, P06D1, P160D, P160E, P161C, or P2610 (ECM, LAU/LBW)



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0602



- Control Module Not Programmed



DTC P0603



- Control Module Long Term Memory Reset



DTC P0604



- Control Module Random Access Memory Performance



DTC P0605



- Control Module Programming Read Only Memory Performance



DTC P0606



- Control Module Processor Performance



DTC P0610



- Control Module Vehicle Options Incorrect



DTC P0614



- Engine Control Module/Transmission Control Module Programming Not Plausible



DTC P0630



- VIN Not Programmed or Mismatched - Engine Control Module (ECM)



DTC P06D1



- Control Module Ignition Coil System Circuitry Performance



DTC P160D



- Incorrect Engine Calibration Detected



DTC P160E



- Engine Calibration Monitoring Not Programmed

No comments:

Post a Comment