Thursday, February 20, 2020

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2501

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 2501

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid valve assembly replacement, setup,

and programming.

P0564

DTC P0564, P0567, or P0568

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0564

- Cruise Control Multifunction Switch Circuit

DTC P0567

- Cruise Control Resume Switch Circuit

DTC P0568

- Cruise Control Set Switch Circuit

Diagnostic Fault Information

Circuit/System Description

The cruise control switch is an input to the body control module (BCM). The BCM monitors the cruise control on/off, set/coast, resume/accelerate

and cancel switches via the cruise control switch signal circuit in order to detect when the driver has requested to perform a cruise control function.

The BCM detects a specific voltage signal on the cruise control switch signal circuit when a switch is applied. The BCM sends a serial data

message to the ECM indicating the status of the cruise control switches.

Conditions for Running the DTC

* The ignition is ON.

* The cruise switch is ON.

Conditions for Setting the DTC

P0564

The ECM detects an invalid voltage signal on the cruise control switch signal circuit for greater than 2 seconds.

P0567

The ECM detects that the Resume switch is applied for longer than 90 seconds.

P0568

The ECM detects that the Set/Coast switch is applied for longer than 90 seconds.

Actions Taken When the DTC Sets

No comments:

Post a Comment