Thursday, January 30, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1185

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1185



Circuit/System Description



The engine control module (ECM) controls boost using the turbocharger wastegate solenoid valve. The wastegate valve is actuated by a rod from



the diaphragm box located at the housing. A spiral spring in the diaphragm box works in the closing direction while the pressure in the diaphragm



works in the opening direction. The ECM supplies a pulse width modulation (PWM) signal to a solenoid valve, which then allows pressure from



the turbo to come through. When the pressure overcomes the spring force in the diaphragm box, the rod begins to move, opening the wastegate



valve to a corresponding degree. The ECM changes wastegate valve opening by varying the PWM signal, which regulates the turbine speed.



Ignition voltage is supplied directly to the wastegate solenoid valve. The ECM controls the solenoid valve by grounding the control circuit with a



solid state device called a driver. The driver is equipped with a feedback circuit that is pulled-up to a voltage. The ECM can determine if the control



circuit is open, shorted to ground, or shorted to a voltage by monitoring the feedback voltage.



Conditions for Running the DTCs



* The engine speed is greater than 80 RPM.



* The battery voltage is between 10-18 V.



* The ECM has commanded the wastegate solenoid valve ON and OFF at least once during the ignition cycle.



* The DTCs run continuously within the enabling conditions.



Conditions for Setting the DTCs



P0244



The ECM detects the wastegate solenoid valve control circuit is open.



P0245



The ECM detects the wastegate solenoid valve control circuit is shorted to ground.



P0246



The ECM detects the wastegate solenoid valve control circuit is shorted to voltage.



Action Taken When the DTCs Set



DTCs P0244, P0245, P0246 are Type B DTCs.



Conditions for Clearing the MIL/DTCs



DTCs P0244, P0245, P0246 are Type B DTCs.



Reference Information



Schematic Reference



Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics



(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Turbocharger System Description (See: Powertrain Management/Fuel Delivery and Air Induction/Turbocharger/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

No comments:

Post a Comment