2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1176
瀚慖f greater than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal,
replace the K20 ECM.
7. If the circuits test normal, test or replace the B65 intake air pressure and temperature sensor.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Turbocharger Pressure Sensor Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Turbocharger/Service and
Repair/Turbocharger Pressure Sensor Replacement) for intake air pressure and temperature sensor replacement
* Control Module References (See: Testing and Inspection/Programming and Relearning) for engine control module replacement, setup, and
programming
P0237
DTC P0236, P0237, or P0238
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0236
- Turbocharger Boost System Performance
DTC P0237
- Turbocharger Boost Sensor Circuit Low Voltage
DTC P0238
- Turbocharger Boost Sensor Circuit High Voltage
Diagnostic Fault Information
Typical Scan Tool Data
Circuit Description
The boost pressure sensor is integrated with the intake air temperature (IAT) sensor. The boost pressure sensor measures the range of pressures
between the turbocharger and the throttle body. Pressure in this portion of the induction system is affected by the following:
No comments:
Post a Comment